Sun Microsystems Sun Workstation 100U System Manager's Manual page 8

Introduction
Sun 100/150 Installation and Maintenance
Hardware and SY8tem Documentation
Part
Description
Number
800-1011
Fujitsu M2351A/ AF Mini-Disk Drive CE Manual
800-1005
Xylogics Model 450 Peripheral Processor SMD Disk Subsystems
Maintenance and Reference Manual
800-1052
Zilog Serial Communications Controller Technical Manual
800-1104' Fast Floating-Point Processor System Integration Manual
Table 2: Software Documentation
Software Documentation
Part
Description
Number
800-1107 User's Manual for the Sun Workstation
800-1108 System Interface Manual for the Sun Workstation
800-1115 Programmer's Reference Manual for SunCore
800-1116 Programmer's Reference Manual for SunWindows
800-1117 System Internals Manual for the Sun Workstation
Notations Used In This Guide
References to commands and utilities Crom the U,er', Manual/or the Sun
UNIX
Sydem and the
S"ltem Inter/ace Manual for the Sun
UNIX
S"ltem use the notation:
pa"wd(l)
to indicate the pa"wd page in section 1 of the User's Manual. (The User's Manual contains sec-
tions 1, 6, and 7.)** Similarly, pa"wd(5) means refer to the pa"wd manual page in section 5
of the System Interface Manual. (The System Interface Manual contains sections 2, 3, 4, and
5.) The notation ,pline(lG) means that this is a Graphics command in section 1 of the User's
Manual. Finally) / etc/reboot(8) implies that this is a command from section 8, which is in this
manual. (The System Manager's Manual contains section 8.)
•• For an explanation of this weird numbering scheme, see the Introduttion to tAe Sun
UNIX
S,I ltem
Mt",u41, in the User's Ma.nual.
-x-