Sun Microsystems Sun Workstation 100U System Manager's Manual page 26

Unpacking and Setting up the 150U
Sun 100/150 Installation Manual
2.3.1. 150U Monitor - Unpacking
Note that the ,hipping weight
0/
the ModellS0U monitor and it, ,hipping carton i, approzimately
80 pound,. The weight
0/
the monitor it,elf i, about 70 pound,.
1. To open the monitor's shipping carton, cut the binding straps on it with a knife or scissors.
The shipping carton is in the form of a square 'tube' with two lids on it, one on the bottom,
and one on the top. The monitor is (:ilcased in styrofoam packing materials inside the lids.
2. Remove the top lid from the 'tube', and you will find the keyboard, the power cord, the dis-
tribution tape(s), and an envelope containing manuals in the recesses in the top of the pack-
ing material. Remove these item,.
3. Lift out the rubber and styrofoam packing material (the fit is fairly tight; try rocking it
out). At this point you may find a mouse and mouse pad boxed and tucked along the side
of the monitor; if you ordered an 84-MByte disk subsystem, these will be packed with it
instead.
4. Remove the square 'tube
7
trom its bottom lid. Don't try to lift the monitor out of the ship-
ping carton: it's too heavy. When you remove the 'tube' from the bottom lid, the monitor is
left standing in the bottom piece of packing material. Two people can then lift the monitor
out of the bottom shipping material, remove the plastic wrapping, and place the monitor on
its working surface.
We recommend that you save the salvageable shipping carton and packing material for future
use in case the product must be reshipped.
2-4
Revision H of 12 March 1984