Table of Contents
Advertisement
OWNER’'S
INFORMATION
Programming time and temperature
You can set your replace to come on before you wake up and turn off after you leave
and then, turn on again just before you come home and turn off after going to bed.
You can leave it like this for the heating season.
1. Decide what temperature you want your replace to be at. Also, decide what time
you want your replace to turn on and off. Finally, decide what time you want it to
come back on and off in the afternoon or evening. For the rst few times you set
the timer, it’' s handy to write these times down.
2. Set the temperature (just as you did in the section Setting the temperature.)
3. Press the TIMER button and hold it until P1
While ashing, push the buttons
which you want your replace to turn on in the morning.
4. Press the TIMER button and hold it until P1
ashing, push the buttons
want your replace to turn off when you leave.
5. Press the TIMER button and hold it until P2
While ashing, push the buttons
which you want your replace will turn back on in the afternoon.
6. Press the TIMER button and hold it until P2
ashing, push the buttons
want your replace to turn off in the evening.
7. That is all you have to do. Your replace will give you steady, even heat at the
temperatures and times you set.
Note: If you want to set your replace for only one time on and off, set P2
for the same times as P1 . The remote will record the P1
To temporarily override the timer setting, just press AUTO or
manual settings. Press TIMER to go back to your settings.
Battery Replacement
When your remote control displays BATT, you need to replace the battery with a
new 9 volt alkaline battery——6LR61/MN1604.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
10
Remote Control Operation
appears and flashes. Let go.
(hour) and
(minutes) to set the time at
appears and ashes. Let go. While
(hour) and
(minutes) to set the time at which you
appears and ashes. Let go.
(hour) and
(minutes) to set the time at
appears and ashes. Let go. While
(hour) and
(minutes) to set the time at which you
and P2
off time for both P2 times.
and
to go back to
Advertisement
Table of Contents
