Table of Contents
Advertisement
7. Reinstall the window.
a. Hook the window over
the top edge of the
rebox, and fasten
the bottom two
spring- loaded
bolts by pushing
in and turning
them 90
degrees.
Spring-loaded
Fastening Studs (2)
b. If the Hot Glass Warning plate has been
removed from the front lower corner of the
window, reinstall it by sliding it between the
glass and the frame as indicated.
Hot Glass Plate
8. Reinstall the barrier screen.
WARNING
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the replace window
screen is re-installed on the replace window
after maintenance.
after maintenance.
a. Hook the bottom of the screen to the bottom
edge of the window frame and then push the
screen against the window frame.
Convection baf e
Top view——Hook bottom of screen to bottom of
window frame
Owner’' s Information
b. While holding the screen, swivel down the top
1/4 Turn
Checks
periodic check of the pilot and burner ames should
A
be made. Check after the re has been on for at least
30 minutes. The pilot ame must cover the tip of the
thermocouple probe. The main burner ame pattern will
vary from appliance to appliance depending on the type of
installation and climatic conditions——see images below.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
ammable vapors and liquids. Inspect the vent terminal
outdoors regularly to make sure that, snow, leaves,
bushes, trees, etc, do not obstruct it. Examine the vent
system and terminal regularly. We recommend annually.
levers and push them away from the center to
lock the screen. Check that the screen is solidly
hooked to the window frame.
Correct Flame Picture
Thermocouple
Probe must be
in Flame
OWNER’'S
INFORMATION
Pilot Flame
7
Advertisement
Table of Contents
