Table of Contents
Advertisement
OWNER’'S
INFORMATION
Batteries
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the replace cool rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
Low batteries signal: see page 10.
The remote control receiver of the appliance uses four
alkaline 1.5 V AA batteries and the handset uses one
9 V alkaline battery.
Batteries should last one to two seasons, depending
on usage. Removing the batteries in the off-season
will extend the battery life. Should the batteries loose
power, the control may be operated by manually
turning the control knob at the valve.
To replace the batteries in the remote control
receiver:
1. The receiver is located to the left of the valve and it
is retained to the rebox by a Velcro tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the 4 AA alkaline batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the Velcro tab.
Lighting, Operation and Rating Information
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT! Let the
replace cool rst before touching it.
The Lighting, Operation and Rating information is located
on a plate at the left of the valve under the burner.
To access the plate, remove the cast fret or the bottom
cover, grab the plate and take it out to read it. There is
important information on both sides of the plate.
8
Owner’' s Information
How to Turn Your Fireplace OFF
First, ensure your replace is cooled BEFORE
going ahead.
Locate the gas valve under the rebox.
1. Set the Flame Adjustment Knob clockwise
as possible.
2. Push in the Gas Control Knob slightly and turn it
clockwise
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
The best way to ensure your replace will not turn on is
to turn it off, including pilot——see above.
If you wish to maintain the pilot only without the main
burner coming on, turn the Gas Control Knob to Pilot
position.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance’' s serial number can also be
quoted. This number is on the rating plate, which is
located under the burner.
The replacement parts are shown at the end of this
manual. Please always quote the part number and
description when requesting spare parts.
Vent Safety Switch
This appliance is equipped with a vent safety switch
which, when activated, will turn off the burner and
pilot if the vent is blocked, disconnected, or if there is
excessive down draught.
If the safety switch is activated, wait for it to cool off
before trying to light the appliance again. The safety
switch will cool off and reset itself automatically after
25 to 30 minutes.
In the event that the safety switch is activated
again, contact a quali ed service technician for
inspection.
Should the safety switch require replacement, only
use parts supplied by Miles Industries.
to OFF. Do not force.
Flame
Adjustment
Knob
Gas
Control
Knob
Turn gas valve buttons clockwise
to turn replace OFF.
(including pilot)
as far
Advertisement
Table of Contents
