Table of Contents
Advertisement
Your replace remote control helps you get the comfort, convenience and aesthetics
you want from your gas replace. The remote controls your replace in different
ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings
of time, temperature and automatic ON/OFF can only be programmed when the
function display is fl ashing. Be patient when programming as it can take a few
seconds to set.
Setting the time
The rst thing to do is to set the time.
1. With your thumb, hold down both the AUTO and TIMER buttons until F ashes.
Let go.
2. Note the digital clock on the bottom right hand corner. The
hour; the
button sets the minutes. Set the time.
Note: You must start setting the time while the F is ashing. If it stops ashing,
go back to 1.
3. The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the AUTO button while the display ashes.
4. Let go and wait until the ashing stops. The remote shows the time you set. It
also shows the current temperature.
Setting the temperature
Use this setting when you come in and want to enjoy a speci c temperature.
1. Push the AUTO button until a number and F ash. Let go.
2. While it is still ashing, push the
Let go.
Your replace will reach that temperature and the remote will check the temperature
every ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.
Setting the ame
Use this setting when you want a particular ame level. For instance, you want to
watch ames burn at their highest level and you don’'t mind if the room is too hot.
1. To raise the ame, press and hold the
desired level. Let go.
2. To lower the ame, press and hold the
desired level. Let go.
The ame level will remain just as you set it.
Remote Control Operation
and
buttons to the temperature you want.
button until the flame gets to the
button until the ame gets to the
button sets the
OWNER’'S
INFORMATION
9
Advertisement
Table of Contents
