Viewing The Ipsec Connection Status - Cisco RV215W Administration Manual

Viewing the Device Status

Viewing the IPSec Connection Status

Viewing the IPSec Connection Status
STEP 1
STEP 2
Cisco RV215W Wireless-N VPN Firewall Administration Guide
The IPsec connection status shows the status of active VPN policies on the
device. (These policies are configured on the VPN > Advanced VPN Setup page.)
To view the IPsec connection status:
Choose Status > IPSec Connection Status. The table displays the following
information:
• Refresh Rate—Choose the rate at which you want the data display to clear
and display the newest data.
• Show Simplified Statistic Data—By default, byte data is displayed in bytes
and other numerical data is displayed in long form. To show the bytes in
kilobytes (KB) and the numerical data in rounded-up form, check Show
Simplified Statistic Data.
• Policy Name—Name of the VPN policy for which data is displayed.
• Local or Remote—Displays the local and remote IP addresses.
• Start Time and End Time—Displays the start and end times of the IPsec
connections.
• Duration—Displays the elapsed time for which the connection is or was
active.
• Packet—Displays the received (Rx) and transmitted (Tx) packets on the
connection.
• Byte—Displays the received (Rx) and transmitted (Tx) bytes on the
connection.
• State—Displays the state of the connection (for example, active or not
connected).
• Action—Displays actions you can perform on the connection (for example,
disconnect).
• Ext Action—Displays if you can switch between the primary and the
secondary VPN connections. If the Rollback enable check box on the
Advanced VPN Parameters page is checked, the Switch button is dimmed.
If you made any changes, click Save.
5
21