Adding Or Editing Ike Policies - Cisco RV215W Administration Manual

Configuring VPN
Configuring Advanced VPN Parameters
NOTE
NOTE
STEP 3
STEP 1
STEP 2
Cisco RV215W Wireless-N VPN Firewall Administration Guide
• Enable—Enable the policy.
• Disable—Disable the policy.
• Delete—Delete the policy.
You cannot delete an IKE policy if it is being used in a VPN policy. You must first
disable and delete the VPN policy in the VPN Policy Table.
• Add Row—Add an IKE policy. See
If you have a VPN connection already configured, you cannot add another without
deleting the existing VPN connection.
Click Save.

Adding or Editing IKE Policies

When adding or editing IKE policies, configure the following settings:
• Policy Name—Enter a unique name for the policy for identification and
management purposes.
• Exchange Mode—Choose one of the following options:
- Main—Negotiates the tunnel with higher security, but is slower.
- Aggressive—Establishes a faster connection, but with lowered security.
• Local Identifier—Local IKE identifier.
• Remote Identifier—Remote IKE identifier.
• Redundancy Identifier—The unique identifier for the alternate backup
endpoint used to restore the connection if the original VPN connection fails.
In the IKE SA Parameters section, the Security Association (SA) parameters
define the strength and mode for negotiating the SA. You can configure the
following settings:
• Encryption Algorithm—Choose the algorithm used to negotiate the SA:
- DES
- 3DES
- AES-128
Adding or Editing IKE
9
Policies.
107