Set Remote-Ike-Ident - Cisco Firepower 4100 Command Reference Manual

S Commands

set remote-ike-ident

To specify the remote peer IKE identity for an IPSec tunnel connection, use the set remote-ike-ident command.
set remote-ike-ident remote_ID
Syntax Description
remote_ID
Connection (/security/ipsec/connection) mode
Command Modes
Command History
Release
1.1(1)
Use this command to specify the remote peerʼs IKE ID for an IPSec connection. This identification is used
Usage Guidelines
for peer validation during IKE negotiations.
Example
This example shows how to specify the remote IKE ID for an IPSec connection:
FP9300-A # scope security
FP9300-A /security # scope ipsec
FP9300-A /security/ipsec # enter connection testconn
FP9300-A /security/ipsec/connection # set remote-ike-ident 203.0.113.12
FP9300-A /security/ipsec/connection* # commit-buffer
FP9300-A /security/ipsec/connection #
Command
create connection
set remote-addr
The IKE identification of the remote peer; maximum of 510 characters.
Modification
Command added.
Description
Creates a new IPSec connection.
Sets the remote IP address for an IPSec connection.
Cisco Firepower 4100/9300 FXOS Command Reference
set remote-ike-ident
219