Table of Contents
Advertisement
User Manual of DS-6400HDI-T Decoder
ip2: Enter the IP address of the encoding device to be decoded.
port2: Enter the port No. of the encoding device to be decoded.
chan: Enter the channel No. of the encoding device for decoding.
type: Set the stream type. 0 means main stream and 1 means sub-stream.
username: Enter the user name of the encoding device. Max. length: 32 bytes.
password: Enter the password used for login to the encoding device. Max. length: 16 bytes.
linkmode: Set the protocol to TCP or UDP which is case-insensitive.
Notes:
1) The length of URL should be less than 240 bytes.
2) The URL mode can only be activated when using with the SMS 4.0 or above version of iVMS-4200 client
software.
Click Start Dec to start decoding, and the decoding status can be viewed in the Connection Status or the
4.
Decoding Channel status interface. And you can view the image from the remote encoding device that is
decoded and displayed on the screen.
4.1.3 Configuring Cycle Decoding
Purpose:
Comparing with the dynamic decoding, the cycle decoding means that you can configure multiple input streams
(the remote encoding devices) to one output (the channel displayed on the screen).
Steps:
Click Decode Operation > Decode Mode > Cycle Decoding to enter the Cycle Decoding interface.
1.
Select a decoding channel from the drop-down list which has been configured for the sub-window in Display
2.
Control Configuration interface.
Enter the Cycle Time (1~1000 sec).
3.
The cycle time refers to the time duration for decoding each input signal to the defined channel and
displaying on the screen.
In the IP mode or URL mode area, select an item from the list and click Edit to enter the following interface
4.
to add a new input stream for decoding or edit the existed input stream.
Figure 4.10 Configure Cycle Decoding
19
Advertisement
Table of Contents
