Table of Contents
Advertisement
User Manual of DS-6400HDI-T Decoder
Steps:
Click Decode Operation > Transparent Channel to enter the Transparent Channel settings interface.
1.
Click to select a transparent channel from the list to configure.
2.
Select the Local Serial Port and the Remote Serial Port to RS-485 or RS-232.
3.
Local Serial Port: the serial port used as the transparent channel by the decoder.
Remote Serial Port: the serial port used as the transparent channel by the encoding device.
Note:
When the RS-232 port is used as the Local Serial Port, you must select the operating mode to Transparent
Channel by entering the Configuration > Serial Port Settings > RS-232 Port interface.
Enter the device information in the Remote Host IP Address, Remote Host Port, and the login User Name and
4.
Password of the encoding device.
Figure 4.21 Check Connecting Status of Transparent Channel
Note:
Up to 64 encoding devices are allowed to establish transparent channel transmission with a decoder.
Click Edit to finish the settings.
5.
Click Refresh and the status in the Connection Status will be displayed if the connection is successful.
6.
Figure 4.20 Configure Transparent Channel
25
Advertisement
Table of Contents
