Table of Contents
Advertisement
User Manual of DS-6500DI–T Universal Network Decoder
Remote Host Channel No.: Input the channel No. of the encoding device for decoding. The value 0
represents channel 1, 1 represents channel 2, and so forth.
User Name/Password: Enter the user name and password used for login to the encoding device.
Transmission Protocol: Select the network transmission protocol to TCP, UDP or Mcast. The default
protocol is TCP.
Stream Type: Set the stream type to be decoded and the default type is main stream. The sub-stream is
supported for decoding when the encoding device supports dual-stream.
Click Start Decoding to start decoding, and the decoding status can be viewed in the Connection Status or
4.
the Decoding Channel status interface. And you can view the image from the remote encoding device that
is decoded and displayed on the screen.
4.1.3 Configuring Cycle Decoding
Purpose:
Comparing with the dynamic decoding, the cycle decoding means that you can configure multiple input streams
(the remote encoding devices) to one output (the channel displayed on the screen).
Steps:
Click Decode Operation > Decode Mode > Cycle Decoding to enter the Cycle Decoding interface.
1.
Select a decoding channel from the drop-down list which has been configured for the sub-window in
2.
Display Control Configuration interface.
Enter the Cycle Time (1~1000 sec).
3.
The cycle time refers to the time duration for decoding each input signal to the defined channel and
displaying on the screen.
In the list of IP Mode/URL Mode/DDNS Mode, select an item and click Edit to enter the following
4.
interface to add a new input stream for decoding or edit the existed input stream by IP mode, URL mode or
DDNS mode.
Note:
Refer to Chapter 4.1.2 for configuring the input stream assigned to the cycle decoding channel by IP
mode, URL mode or DDNS mode.
Figure 4.11 Configure Cycle Decoding
20
Advertisement
Table of Contents
