Download  Print this page

Configuring Video Wall Display - HIKVISION DS-6400HDI-T User Manual

Hikvision hd video/audio decoder
Hide thumbs

Advertisement

User Manual of DS-6400HDI-T Decoder
Note:
Refer to Chapter 4.1.2 for configuring the input stream assigned to the cycle decoding channel.
Click OK to save the settings and back to the Cycle Decoding interface, or click Back to back to the Cycle
5.
Decoding interface without saving.
Repeat Step4 and Step5 to edit other input streams for cycle decoding.
6.
You can also click Delete to remove the configured input stream from the list.
Note:
Up to 64 input streams can be configured for each cycle decoding channel.
Click Save to save the configuration of input streams for the cycle decoding.
7.
Example:
Configuration: Decoding Channel: Channel 1, Cycle Time: 10 seconds, input streams configured for decoding:
10.
Result: the video streams from these 10 input channels will be decoded by decoding channel 1 and displayed on
the screen in sequence with the duration of 10 seconds for each.

4.1.4 Configuring Video Wall Display

The DS-6404HDI-T and DS-6408HDI-T support the configuration for the multi-screen video wall display of the
decoded video.
Steps:
Click Decode Operation > Video Wall to enter the following interface:
1.
Figure 4.11 Edit Cycle Decoding of a Channel
Figure 4.12 Configure Input Streams for Decoding
20

Advertisement

Table of Contents
loading

  Also See for HIKVISION DS-6400HDI-T