Seagull Models Turbo Raven Assembly Manual page 23

5) With both the rudder servo and rudder
centered, mark the rudder pushrod at the hole
it crosses in the rudder servo arm using a felt-
tipped pen.
8mm.
7) Elevator and rudder pushrods assembly follow pictures below.
www.seagullmodels.com
arm using a drill bit. Bend the pushrod wire at
the mark made in the last step. Pass the wire
through the servo arm and secure it using a
nylon wire keeper. Remove any unused arms
from the servo horn.
6) Enlarge the outer hole in the rudder servo
M2 lock nut .
M2 clevis.
23