Seagull Models Turbo Raven Assembly Manual page 10

TURBO RAVEN.
Landing Gear.
C/A glue.
7) Tighten the setcrews using a hex
wrench to secure the collars on the axle over
the flat spot to retain the wheel as shown.
Locker glue.
10
wheel Pant.
Instruction Manual
Repeat steps as above to attach remain-
ing wheel pants to the landing gear.
INSTALLING THE MAIN LANDING GEAR
TO FUSELAGE.
8) The blind nuts for securing the landing
gear are already mounted inside the fuselage.
9) Using the hardware provided, mount
the main landing gear to the fuselage.
10) Place the fuselage inverted on the
workbench in a suitable stand. Set the landing
gear in place and use a screwdrive to secure
the landing gear to the fuselage using bolts
M4x20mm and washers. Make sure to use the
threadlock on the bolts so they don't vibrate
loose.
Locker glue.
M4 x 20mm.
INSTALLING THE FUSELAGE SERVO.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.