Installing The Aileron Servos - Seagull Models EDGE 540 Instruction Manual

EDGE 540
When cutting through the covering to re-
move it, cut with only enough pressure to
only cut through the covering itself. Cutting
into the balsa structure may weaken it.
5) Slide the vertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
Horizontal 90º
Stabilizer.
6) When you are sure that everything is
aligned correctly, mix up a generous amount of
30 Minute Epoxy. Apply a thin layer to the mount-
ing slot in the top of the fuselage and to the sides
and bottom of the vertical stabilizer mounting
area. Apply epoxy to the bottom and top edges
of the filler block and to the lower hinge also.
Set the stabilizer in place and realign. Double
check all of your measurements once more be-
fore the epoxy cures. Hold the stabilizer in place
with T-pins or masking tape and remove any
excess epoxy using a paper towel and rubbing
alcohol. Allow the epoxy to fully cure before
proceeding.
C/A glue.
Rudder.
14

INSTALLING THE AILERON SERVOS.

Vertical
Stabilizer.
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
works well
the wing as indicated.
carefully thread it though the wing. Once you
have string the lead throught the wing, remove
the string so it can use for the other servo
lead. Tape the servo lead to the wing to prevent
it from falling back into the wing.
Instruction Manual
Small weight.
Servos.
Because the size of servos differ, you
Using a small weight (
) and string, feed the string through
Small weight.
String.
Small weight.
Attach the string to the servo lead and
Electric wire.
String.
Weighted fuel pick-up
String.
Wing bottom.
String.