Disassembly
Removing and Replacing the Flip Assembly Cover and CLI Lens
28
1.
Remove the battery cover, battery, antenna, rear housing, and transceiver
board assembly as described in the procedures.
2.
Remove the 4 flip assembly screw caps.
3.
Use the T-5 driver to remove the 4 screws from the flip assembly (see Figure
11). Retain the screws for re-assembly.
Figure 11. Removing the Flip Assembly Screws
4.
Before removing the flip cover, note the locations of the smart buttons on the
sides of the flip assembly.
November 03, 2006
Screw Caps
Screw Caps
Screws
Screws
V3m
051349/051350o
6809501A48-A