Removing And Replacing The Flip Assembly And Transceiver Board - Motorola E815 Service Manual

Level 2 Service Manual

Removing and Replacing the Flip Assembly and Transceiver Board

6809492A18-B
5. Lift the keyboard stiffener away from the phone.
6. To replace, align the keyboard stiffener to the transceiver board.
7. Connect the keyboard flex connector to its socket on the transceiver board.
8. Ensure that the tab at the north end of the keyboard stiffener is above the
hinge flex. Then lower the keyboard stiffener onto the transceiver board. Keep
the tab above the hinge flex, but do not engage the hooks until step 9.
9. With the keyboard stiffener almost parallel to the transceiver board engage
the hooks on each side of the keyboard stiffener. Do not pull the keyboard
stiffener away from the hinge flex any more than necessary to engage the
hooks.
10. Lower the keyboard stiffener onto the transceiver board. When complete, the
conductive pad should be compressed between the keyboard stiffener and the
hinge flex, NOT bunched up between the hinge flex and the PCB.
11. Insert and tighten two screws near the polyphonic speaker assembly.
12. Replace the speaker cover, keypad bezel, antenna, battery, and battery cover
as described in the procedures.
1. Remove the battery cover, battery, antenna, keypad bezel, speaker cover, and
keyboard stiffener as described in the procedures.
2. Use the T6 driver to remove the two flip assembly screws. Set the screws aside
for reuse (See Figure 11).
Figure 11. Removing the Flip Assembly Screws
January 24, 2006
flip assembly
screw locations
Disassembly
032216o
23