Removing And Replacing The Flip Inner Cover - Motorola A780 Service Manual

Digital wireless telephone 850, 900, 1800, and 1900mhz

Hide thumbs Also See for A780:

Table of Contents

Level 1 and 2 Service Manual

Removing and Replacing the Flip Inner Cover

6809488A90

Remove the battery cover, battery, SIM card, stylus, rear housing, and

transceiver board assembly, and flip assembly as described in the procedures.

Use the metal tweezers to remove the 2 rubber screw covers at the base of the

flip. Retain the screw covers for reassembly.

Using a Torx driver with a T-6 bit, remove the 2 screws at each corner of the

unit. Retain the screws for reassembly.

Using the disassembly tool, gently pry the flip cover from the flip assembly

disengaging the flip inner cover latches. See Figure 11.

Flip Cover

Figure 11. Removing the Flip Inner Cover

To replace, position the flip inner cover on to the flip assembly and press until

all of the flip cover latches snap into place.

Replace the 2 screws and tighten to a final torque setting of 1.5 inch pounds

or. Do not over tighten.

Replace 2 rubber screw covers.

Replace the flip assembly, transceiver board assembly, rear housing, stylus,

SIM card, battery, and battery cover as described in the procedures.

Flip Cover Latches

September 20, 2004

Disassembly

Disassembly Tool

Table of Contents