Removing And Replacing The Flip Cli Lens Assembly - Motorola V600 Service Manual

Digital wireless telephone level 1 and 2 service manual

Hide thumbs Also See for V600:

Table of Contents

Disassembly

Removing and Replacing the Flip CLI Lens Assembly

Remove the battery cover, battery, SIM, antenna, rear housing, and

transceiver board assembly and flip assembly as described in the procedures.

Remove the flip assembly cover (see Figure 14a).

Remove the 4 flip assembly screws (see Figure 14b). Be careful not to loose the

flip cover latches attached to 2 screws near the flip assembly hinge. Set the

screws and latches aside for re-use.

Release the 2 latches on each side of the flip assembly (see Figure 14).

Disconnect the CLI flex connector from the flip assembly PCB located under

the CLI lens assembly.

Lift the CLI lens assembly away from the flip assembly.

Flip Cover Screws

Figure 14. Removing the Flip CLI Lens Assembly Part 1

October 10, 2003

Flip Assembly Cover

Flip Cover Screws

V600

Flip Assembly CLI Lens

Flip DIsplay Flex

CLI Lens Assembly

Flip Cover Latch

6809468A79-O

Table of Contents