Removing And Replacing The Flip Assembly - Motorola V600 Service Manual

Digital wireless telephone level 1 and 2 service manual

Hide thumbs Also See for V600:

Table of Contents

Disassembly

Removing and Replacing the Flip Assembly

Remove the battery cover, battery, SIM, antenna, rear housing, and

transceiver board assembly as described in the procedures.

Remove the knuckle from the flex cable and flip assembly (see Figure 13A).

Carefully slide the display flex cable through the keypad housing assembly

(see Figure 13b). Avoid damage to the flex cable.

Lift the keypad housing assembly away from the flip assembly. Be careful not

to damage the display flex cable.

Figure 13. Removing the Flip Assembly

To replace, carefully thread the display flex connector through the slot on the

keypad housing assembly. Avoid damage to the flex cable.

Place the flip knuckle over the flex cable and align knuckle to keypad housing.

October 10, 2003

Flip Assembly Knuckle

Keypad Housing

Display Flex Connector

Flip Assembly

V600

Flip Assembly

Keypad Housing

031648o

6809468A79-O

Table of Contents