Motorola V3m Service Manual page 24

Disassembly
G
24
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
6. Use the disassembly tool to unseat the display flex connector and the keypad
flex connector from their sockets.
7. Lift the rear housing assembly away from the phone.
8. To replace, carefully align the display flex connector to it's socket on the rear
housing assembly, then gently press down on the flex connector until it is
properly seated in it's socket.
9. Carefully align the keypad flex connector to it's socket on the rear housing
assembly, then gently press down on the flex connector until it is properly
seated in it's socket.
10. Rotate the rear housing assembly so it sits over the phone.
11. Align the housing latches with the corresponding openings on the front
housing. Gently press the housings together until the catches snap into place.
12. Cover the display flex with new battery insulator material. Do not reuse the
old battery insulating material.
13. Replace the 2 housing screws and tighten to a final torque setting of 24 Ncm
(2.2 inch pounds). Do not over tighten.
14. Replace the antenna, battery, and battery cover as described in the procedures.
November 03, 2006
V3m
6809501A48-A