Prepare The Fireplace; Nailing Flange Assembly & Installation; Top Stand-Off Adjustment - kozy heat 56701 Installation Manual

NAILING FLANGE ASSEMBLY & INSTALLATION
1. Remove (4) nailing flanges from fireplace sides.
2. With the 1/2" (13mm) long stand-offs on nailing flanges facing away from fireplace, align nailing flange with holes on outside corners
of fireplace. Secure with screws (provided in components packet) through slots in nailing flanges.
3. Bend perforation on nailing flange until parallel with fireplace face. Do not bend toward fireplace face.
4. Position framing stud against 1/2" (13mm) long stand-off (located on backside of nailing flange). Secure with nails or screws.
NOTE Depending on facing material, tabs can be adjusted forward or back wards up to 1/2" (13mm).
CAUTION Never permanently remove these assemblies from fireplace - they must be secured in place regardless of finish material used.
When installed, nailing flanges provide the minimum 1/2" (13mm) clearance from fireplace sides.
BACK VIEW
1/2" (13mm) LONG
STAND-OFF FLANGE
AS SHIPPED
Figure 7a

TOP STAND-OFF ADJUSTMENT

The top stand-off is adjustable to accommodate finish material thickness (non-combustible material only).
TO ADJUST: Loosen screws at fireplace top, slide top stand-off to desired position, retighten screws.
TOP STAND-OFF
ADJUSTMENT SLOTS
Figure 7b

PREPARE THE FIREPLACE

NAILING FLANGES
FRONT VIEW
INSTALLED
TOP VIEW
7
1/2" (13mm) LONG
STAND-OFF FLANGE
NAILING FLANGE
FRAMING STUD
FRAMING
STUD
1/2" (13mm)
CLEARANCE
NAILING
FLANGE