kozy heat 56701 Installation Manual page 24

#TRF-500B LOG SET INSTALLATION
If installing optional brick refractory please do so now before installing log set. Follow instructions included with kit.
ATTENTION
If converting to LP (propane) gas do so now before installing log set. Follow instructions included with kit.
NOTE Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
CAUTION
soot to build up on logs and glass.
LP GAS MODELS (only)
If installing an optional firebrick refractory set, the break-away tab at front of LP log plate will need to be removed. Position LP log plate
onto back log bracket. When properly seated, sides of log plate sit between back log brackets and burner heat shield sides.
Figure 23a
#1 LOG PLACEMENT
Place #1 log onto back log brackets, aligning log bracket pins with alignment
holes in bottom of log while positioning notched out section of log over pilot
shield. Set down onto mounting pins.
LP GAS MODELS: Position back log to create 1/4" (6mm) air space
between back of burner and front of log.
NATURAL GAS MODELS: Position back log so front side of log is
resting against backside of burner tube.
#2 & #3 LOG PLACEMENT
Place left side alignment hole on base log #2, and right side alignment hole on
base log #3 over pins on front log brackets, positioning cut-outs on logs over log
grate. Press logs down onto pins.
BURNER HEAT SHIELD
LP LOG PLATE
BREAK-AWAY TAB
BACK LOG BRACKET
Figure 23b
Figure 23c
23
1
3
2