Thermostat / Wall Switch / Remote - kozy heat 56701 Installation Manual

THERMOSTAT / WALL SWITCH / REMOTE

If desired, a thermostat (wireless style also available), wall switch, or remote control assembly may be used to turn fireplace OFF and ON.
Only ONE of these may be installed. Follow instructions included with chosen assembly.
NOTE
INSTALLATION OF THERMOSTAT OR WALL SWITCH SHOULD ONLY BE PERFORMED BY A QUALIFIED INSTALLER.
CAUTION
DO NOT CONNECT HIGH VOLTAGE (115V) WIRE TO THE GAS VALVE!
Thermostat Wiring Diagram
Figure 5a
WALL SWITCH / THERMOSTAT:
Run low-voltage (thermostat) wires from terminals on gas valve to desired location of wall switch or thermostat.
Attach appropriate connectors to wall switch / thermostat wires and connect to top and bottom terminals marked TH/TPTH on gas valve.
REMOTE CONTROL:
Follow instructions included with remote control
If ON/OFF rocker switch wires are not disconnected, the ON/OFF rocker switch on millivolt board must be in OFF position for
proper operation of any of these components.
IMPORTANT
If rocker switch is ON, fireplace burner will operate until it is turned OFF by rocker switch. A wall switch, thermostat, or
remote control will not turn fireplace OFF when it has been turned ON by the rocker switch.
Fireplace must be turned ON and OFF by same method. For example: If fireplace is turned ON by remote control, it must be
NOTE
turned OFF by remote control.
IMPORTANT The insulated cover included with remote control must be placed over remote receiver to prevent overheating.
Remote Control Wiring Diagram
.
5
Disconnect ON/OFF rocker switch
OPTIONAL
wires from back of gas valve.