Installing Left-Side Components - Arctic Cat 2014 400 ATV Service Manual

Installing Left-Side
Components
A. Starter Idler Gears
B. Rotor/Flywheel
1. Place the crankshaft bearing retainer into position.
Apply red Loctite #271 to the three cap screws.
Install and tighten the three cap screws securely.
2. Install the starter motor and tighten the two cap
screws to 8 ft-lb.
3. Install the shift detent cam making sure the washer is
properly positioned.
4. Install the cam stopper assembly.
5. Install the gear shift shaft assembly and washer mak-
ing sure to align the alignment marks.
56
FI580
6. Install starter idler gear (No. 2) and starter idler gear
(No. 1).
7. Place the key into its notch; then slide the rotor/ fly-
wheel (with the ring gear in place) over the crank-
shaft. Tighten the nut to 107 ft-lb.
C. Cover

NOTE: Steps 1-7 in the preceding sub-section must
precede this procedure.
8. Install two alignment pins and place the left-side
MD1122 cover gasket into position. Install the left-side cover.
Noting the different-lengthed 6 mm cap screws, the
position of the shifter bracket, and the location of the
long cap screw with the washer, tighten cap screws
in a crisscross pattern to 8 ft-lb.
9. Place the outer magneto cover into position on the
left-side cover; then install and tighten the four cap
screws securely.
MD1086
MD1239
MD1305