Disassembling Crankcase Half - Arctic Cat 2014 400 ATV Service Manual


NOTE: To keep the shaft/gear assemblies intact for
identification, tap the shafts toward the left-side
crankcase half when separating the halves.
Disassembling Crankcase
Half
1. Remove the secondary and primary driveshaft
assemblies. Account for the bearing alignment
C-ring on the bearing boss next to the driven gear.

NOTE: Note the location of the bearing alignment
pin on the secondary output shaft.
2. Remove the reverse idler gear, spacer, and sleeve.
Account for the washer.
CC869
3. Remove the driveshaft.
4. Remove the shift fork shaft and the outer shift fork.
MD1313
5. Remove snap ring and gear from the output side of
the gear cluster. Remove the gear cluster and the
inner shift fork together. Account for snap ring, gear,
and washer.
MD1317
MD1325
MD1326
MD1327
MD1328
65