Handlebar Grip; Throttle Control - Arctic Cat 2014 400 ATV Service Manual

3. Install the new gauge and mounting bracket; then
connect the wiring harness to the gauge.
4. Put the instrument pod into position making sure the
rear tab is in position first; then install the screws on
the front.

Handlebar Grip

REMOVING
1. Loosen but do not remove the cap screw in the end of
the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
26
KC516B
2. Grasp the end and remove the cap screw, plug, and
end cap.
3. Using a sharp utility knife, split the handlebar grip
from end to end and peel off the rubber.
KC516C
4. Using an adhesive solvent, clean all glue residue
from the handlebar.
INSTALLING
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of the new grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.

NOTE: A quick, firm push is required to seat the
grip completely on the handlebar. Install while the
glue is wet.
3. Wipe off any excess glue; then secure the grip with
the plug, end cap, and cap screw.

Throttle Control

REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
KC310
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
KC309A
KC308