Joining Crankcase Halves - Arctic Cat 2014 400 ATV Service Manual

11. Install the secondary output driveshaft assembly into
the crankcase half making sure the front and rear
bearing alignment pins are seated in the recesses;
then install the center carrier bearing alignment
C-ring.

Joining Crankcase Halves

1. Verify that the two alignment pins are in place and
that both case halves are clean and grease free.
Apply Three Bond Sealant to the mating surfaces.
Place the right-side half onto the left-side half.
FI645
2. Using a plastic mallet, lightly tap the case halves
together until cap screws can be installed.
3. From the right side, install the crankcase cap screws
noting the location of the different-sized cap screws;
then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs while tightening the
cap screws.
FI660A
FI659A
4. From the left side, install the remaining crankcase
cap screws; then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs while tightening the
cap screws.
FI661A
MD1336
MD1008
73