Installing Engine/Transmission - Arctic Cat 2014 400 ATV Service Manual

5. In a crisscross/case-to-case pattern, tighten the 8 mm
cap screws until the halves are correctly joined; then
tighten to 21 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
6. In a crisscross/case-to-case pattern, tighten the 6 mm
cap screws to 10 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
AT THIS POINT

After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Installing
Left-Side Components, and to Installing Top-Side Com-
ponents.
Installing
Engine/Transmission
1. From the right side, place the engine/transmission
into the frame tilting the top-side forward to clear the
frame member.
2. Install the front and rear engine mounting
through-bolts and secure with the flange nuts.
Tighten to 38 ft-lb.
3. Align the front and rear output flanges with the drive
couplers; then secure with the screws and tighten to
20 ft-lb.
74
CC871
4. Install the front and rear V-belt cooling boots and
secure with the existing hardware.
KC216
5. Connect the stator coil, trigger coil, and gear position
switch connectors; then attach the engine ground
cable and starter cable and secure with cap screws
and nuts. Tighten to 8 ft-lb.
KC242
KC243
KC235
KC236