Rear Body Panel/Rack - Arctic Cat 2014 400 ATV Service Manual

6. Remove the electric panel; then disconnect the LCD
gauge connector, ignition switch, and accessory out-
let.
7. Remove the front body panel/fender panel.
CLEANING AND INSPECTING
1. Clean all fender components with warm soap and
water.
2. Inspect fenders for cracks and/or loose rivets.
3. Inspect for any missing decals.
INSTALLING
1. Making sure the shift spring is in place and the shift
lever is properly positioned, place the front body
panel/fender panel onto the ATV. With the front rack
in place, loosely install the front rack hardware.
2. Connect the electrical connectors under the electric
panel; then connect the light connectors and attach
onto the frame.
22
3. Install the screws securing the front body to the front
body supports; then install the left-side and right-side
footwell fasteners. Do not tighten at this time.
4. Place the gas tank cover into position and secure
with the existing hardware; then install the two cap
screws securing the rear of the panel to the frame.
Tighten all cap screws and fasteners securely.
5. Install the electric panel, side panels, and seat.

Rear Body Panel/Rack

REMOVING
1. Remove the rear rack; then remove two cap screws
KC210G
securing the rear body panel/fender to the side frame
and the cap screws securing the rear fenders to the
footwells.
2. Disconnect the battery (negative cable first) and
KC210G
remove from the battery compartment; then discon-
nect the starter relay wires and route the wiring out
of the compartment.
KC224
KC317A
KC316