Suzuki DF 90 Service Manual page 37

2-12 PERIODIC MAINTENANCE
6. Install shim. Identification number should face towards tap-
pet.
7. Rotate crankshaft to be open (lift up) valve.
8. Remove tappet holder 1 and tighten camshaft housing bolts
to specified torque.
Camshaft housing bolt :
9. Recheck tappet clearance.
NOTE:
After completing tappet clearance adjustment and securing
camshaft housing bolts, inspect tappet clearance again.
INSTALLATION
After checking and adjusting all tappet clearances, install cylin-
der head cover. Installation is reverse order of removal.
(See page 6-10)
Cylinder head cover bolts :
11 N . m (1.1 kg-m, 8.0 lb.-ft.)
11 N . m (1.1 kg-m, 7.0 lb.-ft.)
2
1
1 Special tool
2 Tappet
3 Camshaft
3