Suzuki DF 90 Service Manual page 374

FORWARD GEAR/PROPELLER SHAFT / BEARING
HOUSING
• Assemble the propeller shaft in the following sequence:
99000-25161 : Water Resistant Grease
99000-22540 : Suzuki Outboard Motor Gear Oil
(a) Apply Water Resistant Grease to O-ring 1, then install the
O-ring into the groove on the propeller shaft bearing hous-
ing.
(b) Install shim 2, bearing washer 3, propeller shaft thrust
bearing 4, propeller shaft thrust washer 5 into propeller
shaft bearing housing 6.
(c) Install F-gear back-up shim 7, F-gear thrust washer 8,
F-gear thrust bearing 9 and forward gear 0 to propeller
shaft bearing housing.
(d) Slide propeller shaft A into forward gear and propeller shaft
bearing housing.
(e) Assemble horizontal slider B to connector pin.
To hold the correct bearing position, pull propeller shaft back-
ward and then install propeller shaft and housing assembly in
the gearcase.
NOTE:
To make the bearing housing fully seated in the gearcase, tap
the housing gently with plastic mallet.
DF140 "K2" ('02) MODEL 11-81