Suzuki DF 90 Service Manual page 347

11-54 DF140 "K2" ('02) MODEL
DRIVESHAFT
• Assemble the washer 1, washer (with the tab) 2, wave
washer 3, washer 4 and driveshaft collar 5 to the driveshaft.
• After installing driveshaft collar, fit the convex part of the col-
lar in the concave part of the driveshaft by turning collar.
• Lower the driveshaft assembly 6 down into the gearcase
until the bottom of shaft protrudes through center of pinion.
NOTE:
The washer tab must be located into groove on the gearcase.
• Install bearing outer race 7 and pinion shim 8 to driveshaft.
DRIVESHAFT OIL SEAL HOUSING
Apply Water Resistant Grease to the driveshaft oil seal.
99000-25161: Water Resistant Grease
Apply Water Resistant Grease to O-ring, then install the O-ring
into the groove on the driveshaft oil seal housing.
Install driveshaft oil seal housing on gearcase, then tighten
four (4) bolts securely.