Suzuki DF 90 Service Manual page 272

9-18 LOWER UNIT
PROPELLER SHAFT / BEARING HOUSING
1. Assemble propeller shaft in following sequence :
Forward thrust washer 5, Reverse thrust washer 1,
Reverse gear 2, Reverse gear back-up shim 3,
Propeller shaft housing 4.
99000-25161 : Water Resistant Grease
99000-22540 : Suzuki Outboard Motor Gear Oil
2. Assemble horizontal slider 6 to connector pin.
3. Using special tools, install propeller shaft and housing
assembly in gear case.
09922-59410 : Propeller shaft housing installer
09922-59420 : Housing Installer Handle
4. When housing is fully seated, tighten two bolts to
specified torque.
Bearing housing bolt : 20 N . m (2.0 kg-m, 14.5 lb.-ft.)
RECHECKING DRIVESHAFT THRUST PLAY
Recheck driveshaft thrust play.
This should not be less than previously checked on page 9-17.
(See "RECHECKING DRIVESHAFT THRUST PLAY" section
on page 9-27.)
09951-09530 : Gear adjusting gauge