8-16
POWER TRIM AND TILT
8. Apply Water Resistant Grease to tilt rod upper bushings 6,
then install bushings in tilt rod.
9. Operate PTT motor to extend PTT rod upward.
Align tilt rod with hole in swivel bracket as tilt rod extends.
99000-25161 : Water Resistant Grease
10. Apply Water Resistant Grease to PTT rod upper shaft 7,
then insert shaft through swivel bracket and tilt rod.
99000-25161 : Water Resistant Grease
11. Secure upper shaft with snap ring 8.
12. Route PTT motor cable in through lower cover and connect
terminals to PTT motor relays.
(Cable routing – See WIRE / HOSE ROUTING section
on page 10-2 to 10-5)