Suzuki DF 90 Service Manual page 373

11-80 DF140 "K2" ('02) MODEL
PINION NUT
Apply Thread Lock 1342 to the threads of the pinion nut before
threading it onto the driveshaft.
Tighten nut to the specified torque.
Pinion nut: 120 N . m (12.0 kg-m, 87.0 lb-ft)
99000-32050: Thread Lock 1342
09921-29410: Driveshaft holder
CHECKING DRIVESHAFT THRUST PLAY
Before installing forward gear, driveshaft thrust play should
checked.
(See the "GEARS-SHIMMING AND ADJUSTMENT/CHECK-
ING DRIVESHAFT THRUST PLAY" section on page 11-88.)
Driveshaft thrust play:
Approx. 0.6 – 0.8 mm (0.024 – 0.031 in.)
09951-09511: Gear adjusting gauge
PROPELLER SHAFT
Slide the clutch dog shifter 2 onto the propeller shaft 1.
NOTE:
• For correct installation the side of the clutch dog shifter which
must face towards reverse gear is marked with the letter
"R . E . V".
Insert the connector pin 3 into propeller shaft.
Align the holes in the shifter dog and connector pin and then
slide the dog pin 4 through both dog and connector pin.
Install the dog pin retaining spring 5, ensuring that it fits snugly
into the groove on the dog shifter.
Install the spacer 6 to propeller shaft.
R·E·V