Using The Stand-Alone Battery Charger To Charge The Battery; Inserting The Battery; Procedure - FLIR T4xx series User Manual

15 Handling the camera

15.1.4 Using the stand-alone battery charger to charge the battery

15.1.4.1 Procedure

Follow this procedure:
1. Put the battery in the stand-alone battery charger.
2. Connect the power supply cable plug to the connector on the stand-alone battery
charger.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the green light of the battery condition
indicator is continuous.
See also:
For information about the battery condition indicator, see 8.4 Battery condition indicator,
page 17.

15.2 Inserting the battery

Note
Use a clean, dry cloth to remove any water or moisture on the battery before you insert it.
15.2.1 Procedure
Follow this procedure:
1. Push the release button on the battery compartment cover to unlock it.
2. Open the cover to the battery compartment.
3. Push the battery into the battery compartment until the battery locking mechanism
engages.
#T559772; r.7877/7877; en-US
28