Handling The Camera; Charging The Battery; Using The Power Supply To Charge The Battery When It Is Inside The Camera; Using The Stand-Alone Battery Charger To Charge The Battery - FLIR T10 Series User Manual

13

Handling the camera

13.1 Charging the battery

WARNING
Make sure that you install the socket-outlet near the equipment and that it is easy to get access to.
Note You must charge the battery for 4 hours before you start using the camera for the
first time.
13.1.1 Using the power supply to charge the battery when it is inside the
camera

13.1.1.1 Procedure

Follow this procedure:
1. Put the battery into the camera battery compartment.
2. Connect the power supply cable plug to the power connector on the camera.
3. Connect the power supply mains-electricity plug to a mains socket.
4. To check the status of the battery charging, do one of the following:
• If the camera is turned on: Place your finger at the top of the screen and swipe
down. The battery status is displayed on the swipe-down menu.
• If the camera is turned off: The battery charging indicator is temporarily displayed
on the screen.
5. It is good practice to disconnect the power supply cable plug when the green light of
the battery condition LED indicator is continuous.

13.1.2 Using the stand-alone battery charger to charge the battery

13.1.2.1 Explanation
Type of signal
The blue LED flashes.
The blue LED glows continuously.
13.1.2.2 Procedure
Follow this procedure:
1. Put the battery in the battery charger.
2. Connect the power supply cable plug to the connector on the battery charger.
3. Connect the power supply mains-electricity plug to a mains socket.
4. It is good practice to disconnect the power supply cable plug when the blue LED on
the battery charger is glowing continuously.

13.2 Turning on the camera

13.2.1 Procedure
Follow this procedure:
1. To turn on the camera, push and release the On/off button
#T559954; r. AT/65353/65353; en-US
Explanation
The battery is being charged.
The battery is fully charged.
.
31