Toyota OEKAKI 50 Instruction Manual page 97

EN
LED display
This appears when any of the following
incorrect operations are performed. (The
sewing machine does not operate.)
1 You try to start the sewing machine with
F9 2 In OEKAKI mode, the start/stop button
3 The reverse sewing button is pressed
4 While the bobbin is being wound, the
This appears when an incorrect operation
P0 – 9
was performed with the sewing machine
or PF
turned on.
* Although the above code will disappear after 2 to 3 seconds, the necessary countermeasure should be
performed.
Note
• If the problem is not resolved after the appropriate countermeasure is performed, stop using
the sewing machine and contact your retailer.
• A code between E1 and E9 appearing indicates that the sewing machine has malfunctioned.
Immediately stop using the sewing machine and contact your retailer.
Cause
the start/stop button while the foot
controller is connected.
or reverse sewing button is pressed.
while a buttonhole stitch is selected.
needle up/down button or reverse
sewing button is pressed.
Countermeasure
1 When the foot controller is connected,
start the sewing machine with it.
2 In OEKAKI mode, use the foot
controller.
3 Use the start/stop button or foot
controller with buttonhole stitches.
4 When winding the bobbin, use the start/
stop button or foot controller.
Since the sewing machine is in service
mode, turn it off, then on again.
97