Toyota OEKAKI 50 Instruction Manual page 76

5
Switch to OEKAKI mode.
Turn on the sewing machine, and then switch to OEKAKI
(free-motion embroidering) mode by pressing the
(free-motion embroidering) button so that it lights up in
green.
* If the button is pressed again, it will go off and the sewing
machine will switch to utility stitching mode.
6
From the operation panel, select stitch number A1 or A2.
Press the function button until the
set the stitch number to A1 or A2.
* The stitch number appears in the LED display.
<Stitches that can be used>
No. Application
Zigzag sewing from a left
A1
needle entry point
Zigzag sewing from a center
A2
needle entry point
* When sewing zigzag stitches from a left needle entry point, the stitch width changes with the left side as the
reference.
* When sewing zigzag stitches from a center needle entry point, the stitch width changes with the center as the
reference.
7
Position the fabric under the presser foot, and
then lower the presser foot lever.
76
LED lights up, and then press the
Presser foot
Embroidering foot
OEKAKI
button
(setting) buttons to
Presser
foot lever