Toyota OEKAKI 50 Instruction Manual page 59

EN
❑ When using the zigzag sewing foot
1
Select the stitch in the operation panel.
* Check that the OEKAKI (free-motion embroidering) button is not lit.
* When sewing thin fabrics, select stitch number 5.
* When sewing stretch fabrics, select stitch number 13, 15, 18, 22 or 26.
* Refer to "Selecting the stitch" (page 44).
Suitable stitch
5 13
15
2
Select the stitch width and stitch length.
* Refer to "Selecting the stitch width" (page 45) and "Selecting the stitch length" (page 46).
3
Press the (needle up/down) button to raise the needle.
4
Position the fabric under the presser foot, and then lower the presser foot lever.
5
Position the fabric so that the needle extends
slightly off the edge of the fabric when the
needle moves to the right.
Presser foot to be used
26
18 22
Zigzag
sewing
foot
Right needle entry point
OEKAKI
button
not lit
59