Toyota 6600 Instruction Manual

Toyota 6600 Instruction Manual

3 & 4 thread overlock

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6600 and is the answer not in the manual?

Questions and answers

Cynthia
March 30, 2025

How do I change the width and spacing of stitching

1 comments:
Mr. Anderson
May 14, 2025

To change the width and spacing of stitching on a Toyota 6600 serger:

1. Stitch Width: Adjust the knife position using the dial to control how much fabric is trimmed. Turning the dial so the knife moves to the left cuts off more fabric, reducing bunching and increasing stitch width.

2. Stitch Length: Use the stitch length dial. It was initially set to 1 and was adjusted to about 2.5 for better results. Increasing the number increases the spacing between stitches.

Adjust both settings incrementally and test stitching to achieve the desired result.

This answer is automatically generated

Boyi voke
July 19, 2025

The upper looper is not picking the threads

User image 687bcfcb8a661
Sloan R Berman
June 4, 2025

I have a Toyota 3&4 Thread Overlock but it’s missing the power cord. Can I find a replacement for the cord anywhere?

Table of Contents

Save PDF