Toyota OEKAKI 50 Instruction Manual page 29

EN
While the bobbin is being wound, do not touch the thread winding spindle or the
handwheel.
Doing so could cause injuries.
1
Turn off the sewing machine.
2
Pull up the spool pin, and then place the spool of
thread on it.
3
Pull the thread from the thread spool, and then
hold it with one hand (1) while passing it around
the thread guide with the other hand (2).
4
From the inside, pass the thread through the hole
in the bobbin as shown. Place the bobbin on the
thread winding spindle so the groove aligns with
the shaft projection.
5
Turn on the sewing machine.
Caution
Main power
switch
Thread guide
Hole
Thread
winding
spindle
Main power
switch
Spool of
thread
Spool pin
2
1
Thread
Groove
Bobbin
Shaft
projection
29