Command Formats - Pioneer LD-V8000 Level III User Manual

Command
58 Register C Request (Miscellaneous)
59 Register D Request (RS-232)
60 Register E Request (User Switch 1)
61 Register F Request (User Switch 2)
62 Register G Request (Video Memory)
63 Register H Request (Extended Control)
64 Register I Request (Level II Program)
65 Select Input Unit
66 Input Unit Request
67 Input Number Wait
68 Set AUX Port
69 Set Program Pointer
70 Program Read
71 Program Write
72 Program Pointer Request
73 Program Run
74 Program Halt
Figure 4-E
(cont.)

4.5 Command Formats

Level III commands on the LD-V8000 are expressed as "Command Mnemonics", so
they are easier to remember. "Command Mnemonics" are also used for Level III
control of the LD-V4400, CLD-V2400, LD-V2200, the LC-V330 and the discontinued
LD-V4200. (See Technical bulletin #143, Command Mnemonics for Pioneer
Industrial LaserDisc Players.) Some commands are preceded by an "argument"
that may be a specific "address" or an "integer".
Command Mnemonic
ASCII alphabetic characters. There is no distinction between uppercase letters and
lowercase letters.Example: PL (Play);
Argument
—An argument is expressed in ASCII digits and it is placed before the
command. When a command requiring the argument has no argument, an error
occurs. An argument consists of one of the following:
LD-V8000 Level I & III User's Manual
LD-V8000 Level I & III • Chapter Four
— Each Level III mnemonic command is expressed as two
Pl (Play);
TP 113 v. 2.1 • 2/93
Mnemonic
$C
$D
$E
$F
$G
$H
$I
Integer
#S
#I
?N
Integer #P
Address *S
Integer *D
Integer *W
*P
(Address) *R
*H
pl (Play)
Page
4-60
4-60
4-61
4-61
4-62
4-62
4-63
4-64
4-65
4-66
4-67
4-68
4-68
4-69
4-70
4-70
4-70
4-7