Pioneer LD-V8000 Level III User Manual page 42

Chapter Two • LD-V8000 Level I & III
SWITCH 6
This switch bank is set through the Function Switch Setting Mode and the settings
are stored into Register H.
This switch sets the following player operating characteristics :
Switch Number 6
Bit Position
0
1
2
3
4
5
6
7
Figure 2-T
Bit 0: This bit selects 4 fields or 2 fields in still mode.
Bit 1: This bit assigns AUX 1 as the Output or as the Video Signal Indicator.
Bit 2: This bit assigns AUX 2 as the Output or as the High State Output.
Bit 3: This bit enables or disables sync insertion during squelch.
Bit 4: This bit enables or disables DOC (Drop Out Compensation).
Bit 5: This bit selects the digital or analog audio output as default. It is
usually set to Digital. If there is no Digital on the disc, the player will
default to analog.
Bit 6: This bit selects the input device to either 0 (RCU) or 1 (Serial)
Bit 7: This bit is used to set the Video Delay time to either 4.2 - 16.2 mSec. or to
15.2 - 16.2 mSec. The default setting is 4.2 - 16.2 mSec. For some
applications, especially those requiring precise audio sync, a shorter delay
time is required. (For more information, refer to Pioneer Application Note
#177A, Built-In Audio Sync Lock on the LD-V8000, 12/17/90. Contact
Pioneer LaserDisc Engineering and Technical Support, 201/327-6400. )
2-22
Function
Still Mode
AUX 1 Default Setting
AUX 2 Default Setting
Sync Out (During SQ)
Drop Out Control
Audio Default
Input Device
Video Delay Time
TP 113 v. 2.0 • 2/93
On (=1)
4 Field
Output
Output
Off
Off
Analog
Device 1
(Serial)
4.2-16.2 mSec. 15.2-16.2 mSec.
LD-V8000 Level I & III User's Manual
Off (=0)
2 Field
Video Indicator
High State
On
On
Digital
Device 0
(RCU)