Pioneer LD-V8000 Level III User Manual page 124

Chapter Four • LD-V8000 Level I & III
REGISTER E SET
51) REGISTER E SET
Function: Changes the current setting of Register E. (User's Switch 1)
Format: Integer
Explanation: Register E contains the settings of the function switches which
are stored in the EPROM. These settings are copied to this register
when power is turned on or when they are selected in the
Function Switch Setting Mode. Once power is turned on or you
have exited Function Switch Setting Mode, the settings cannot be
changed. This command can be used to temporarily change the
settings of the functions. It must be noted that changes to some
functions may suspend playback or disable further control.
To set each bit to 1 (ON), give the value indicated in the integer.
Figure 4-Y
To set multiple bits to 1, the integer values must be added up. All
eight functions can be specified in combination by using the
decimal values from 0 to 255.
The completion status is returned immediately.
Execution: These bits are reserved for specific use by programmers.
4-54
Integer Function
1 Bit 0
2 Bit 1
4 Bit 2
8 Bit 3
16 Bit 4
32 Bit 5
64 Bit 6
128 Bit 7
TP 113 v. 2.1 • 2/93
R E
1
ON
ON
ON
ON
ON
ON
ON
ON
LD-V8000 Level I & III User's Manual
0
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF