Pioneer LD-V8000 Level III User Manual page 128

Chapter Four • LD-V8000 Level I & III
REGISTER I SET
55) REGISTER I SET
Function: Changes the current setting of Register I. (Level II Program)
Format: Integer
Explanation: Register I contains the settings of the function switches which are
stored in the EPROM. These settings are copied to this register
when power is turned on or when they are selected in the
Function Switch Setting Mode. Once power is turned on or you
have exited the Function Switch Setting Mode, the settings cannot
be changed. This command can be used to temporarily change
the settings of the functions. It must be noted that changes to
some functions may suspend playback or disable further control.
The following functions can be set. To set a function to 1 (ON),
give the value indicated in the Integer.
To set multiple functions to 1, the integer values must be added
up. All eight functions can be specified in combination by using
the decimal values from 0 to 255.
The completion status will be returned immediately.
Integer
Figure 4-C.1
Execution: * Normal Mode
1 R H <C/R>
* 4 Field still Mode
4-58
Function
1 Dump Execution
2 Dump Load from Disc
4 Not used
8 Not used
16 Not used
32 Not used
64 Not used
128 Not used
TP 113 v. 2.1 • 2/93
R I
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
R <C/R>
LD-V8000 Level I & III User's Manual
1 0
ON
ON