On-Screen Function Switches - Pioneer LD-V8000 Level III User Manual

Chapter Two • LD-V8000 Level I & III

2.4 On-Screen Function Switches

The LD-V8000 videodisc player contains no physical dip-switches for setting
various function parameters. Instead, the function parameters can be set by
controlling on-screen menus with the buttons on the front panel of the player, or
with buttons on an RU-V6000T or RU-V103 remote control unit.
NOTE: Some settings can be modified by entering data into Registers from a
computer via the RS-232 port. (See Section 4.7.7 Register Control Commands.)
2.4.1 Setting Function Switches
Use the following steps to set the on-screen function switches:
1) Function Switch Setting Mode
First, turn the player OFF using the power button on the front of the player.
Then press the DISPLAY button on the front panel of the player while turning
the power back ON. This sets the Function Switch Setting Mode and prepares
the player to receive inputs to set the on-screen function switches. (In Function
Switch Setting Mode, the LD-V8000's front panel LEDs cycle ON and OFF.)
You will see a screen titled "KEY OPERATION P-0." This on-screen "page"
explains which buttons on the front panel of the player allow you to locate,
select and set the function switches. (See Figure 2-O, next page.)
2) Setting Switches Using The Player's Front Panel Buttons or Remote Control
Page Selection
By pressing the SCAN FORWARD button you can move forward
through each of the 13 pages, one at a time. The SCAN REVERSE
button lets you move through the pages in reverse order. Page 1 is
titled "CONTENTS P-1." This tells you the particular page on which
to find the function you want to set.
Item Selection
When you locate the page that contains the function you want, press
the STEP FORWARD button. This will highlight the top function on
the page. Press the STEP FORWARD button until the function you
want to set is highlighted. Pressing the STEP REVERSE button will
toggle through the available options/parameters for that particular
function, allowing you to select the setting.
Modifying the Settings
Continue through additional pages (P-2 through P-7) to set the
switches to your required default settings.
2-12
TP 113 v. 2.0 • 2/93
LD-V8000 Level I & III User's Manual