Level Ii Program Control Commands; Set Program Pointer *S; Program Read *D - Pioneer LD-V8000 Level III User Manual

Chapter Four • LD-V8000 Level I & III
Level II Program Control — SET PROGRAM POINTER; PROGRAM READ

4.7.10 Level II Program Control Commands

69) SET PROGRAM POINTER
Function: Sets address of the program pointer.
Format: Address
Explanation: The program pointer is used for writing to and reading from the
player's RAM.
The available pointer addresses are from 0 to 65545.
The completion status is returned immediately.
70) PROGRAM READ
Function: Transmits program data
Format: Data Length
Explanation: When this command is entered, the player transmits the contents
of RAM. The data transmitted is the length indicated by the
argument and transmission begins at the address defined by the
Set Program Pointer.
The data length can be set from 0 to 64. A unit length is one byte.
Since the output data format is ASCII-HEX, each command is two
bytes so the actual length of data is twice as long as the
commands entered. (A program of 20 commands is 40 bytes
long.) Also the end of the data string terminator <C/R> is
attached.
4-68
* S
*D
LD-V8000 Level I & III User's Manual
TP 113 v. 2.1 • 2/93